Recent content by nismogod

  1. N

    Nitrous Jetting

    http://www.coldfusionnitrous.com/calculator.aspx hope this helps your calculation needs.
  2. N

    WTB Single Piston Rod h22 92-97

    oooo, rod bearing width. my bad.
  3. N

    WTB Single Piston Rod h22 92-97

    why a 92-97 rod? they are the same. i have spare pistons(h22 factory CR), and spare h23 rods. a full set of both.
  4. N

    94 EG Hatch with 97 F22 Accord Drivetrain questions

    i'm sure you meant nitrous, unless you meant the brand NOS. as for the original question or point. good luck. your thoughts appear to be accurate. keep us updated on the build. I'd be cool for a turbo setup.
  5. N

    90 Civic SI Hatch H22 vs. B18C5

    the adapter setup will cost you $1000. Then you need to buy an ITR tranny, and b-series clutch, and flywheel. Also, your gears will be short as hell. And H doesn't rev as high as B. So long as you dont haul ass everywhere, and obey speed limits, you'll be ok with that tranny. But you'll...
  6. N

    90 Civic SI Hatch H22 vs. B18C5

    i say h22. cheaper, and for the initial cost, definately faster. h22 is what i did, i'm very pleased.
  7. N

    H22 Forged pistons installation

    the mahle pistons were just reviewed in some import magazine, if i can find which, i'll let you know.
  8. N

    WTB prelude/accord shift cables

    its pretty much what the title says. i'd like to buy the shift cables/linkage from a prelude or accord. I would be willing to purchase the entire assembly if need be. please let me know AIM: piccolobatman or leave me a message on here.
  9. N

    H-series cam specs

    http://crower.com/cat/import/honda/cams/h22.shtml has stock specs too.
  10. N

    1991 Mustang GT 306 FS/FT

    bump. wish i were local.
  11. N

    N2O block build

    run a single fogger, wet. start with a 50 then move up. remember, 50% of your base crank hp you can add easily. use the MSD 8975 to pull timing only when spraying. that way you keep your base tune. Pull 2 degrees for every 50shot. Or atleast until you learn how to read plugs and what not...
  12. N

    N2O block build

    "seems old school" thats funny. lol. seems the old schoolers are still the fastest. but do as you may. i can't offer much help on a dry system, i wouldn't use one. besides, mike, this is not about your build ;-) its for the thread starter. werd.
  13. N

    N2O block build

    no. i have 1 tune. my car is tuned for no nitrous, with a decent NA map. then i use and MSD 8975 (multistage timing retard) to automatically retard timing as the nitrous solenoid is activated. Go read the instructions, it will show you how it works. you can also use this part to pull timing...
  14. N

    N2O block build

    my car is tuned for no N20, and when the solenoid fires, it automatically pulls proper amount of timing. I run 11:1 CR on factory parts. I dont have an issue. CR does not limit nitrous use.
Back
Top