thanks, anyone else know more about those " eagle H rod's" btw im looking for a low compression setup because will turbo this b18a1 (ls) later on. Have $1000 to spend right now for internals.
I just bought a greddy header for my LS swap, but will that bolt right up to the civic Skunk2 Mega Power R Exhaust System (for my 1994 civic eg)?
Do I need to make any modifications?
So eagle rods are good quality rods from what i see, but on ebay i see:
Eagle H-Beam Rods
eBay Motors: Eagle H-Beam Rods Honda Civic B16 B18 B20 all B Series (item 400004304319 end time Nov-04-08 08:02:58 PST)
Is this the actual eagle rods or knock off brand?
Also are CP and JEpistons...
I just bought the b18a1 LS i told you guys about earlier. I want to turbo this later on so I need to make it a low compression. At the moment we have about $1100 for the motor internals and what not without the turbo. I'm looking at about 300-350HP after the turbo. What kind of cams, pistons...
Ok I'm pulling the motor out of the VX. I un-bolted the following:
top right motor mount (near water pump), bottom right mount (old A/C bracket/mont) top left side mount (by air filter) bottom left mount (a long bolt thing going through a rubber hole, same as the bottom right mount) and I think...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.