Recent content by TheSir

  1. T

    Plug colors (lean or rich)

    Thats perfect thanks alot!
  2. T

    Plug colors (lean or rich)

    So this is a question ive had many different answers from. I would like replies from only people who know what they should actually look like. Im running a obd1 GSR B18c JDM motor with a PR3 ecu, with many mods... including VAFC for some tuning. Im trying to dial in my fuel so im not running to...
  3. T

    Apexi VAFC controller install HELP

    Thanks TurboMirage i figured the jumpdown would be the best spot. Ill fallow the directions and setup perfectly. Wish me luck :P
  4. T

    Apexi VAFC controller install HELP

    So i bought a VAFC controller for the SiR. Dont have the manual, and found one googling for hours finally in a nice .pdf file. The install is fairly complex, but not for a buddy of mine thats very good with wiring cars. What im also looking for is a step by step install guide write up someone...
  5. T

    is spoon P30 work fine for b18c? (db8 jdm P72 integra)

    where are the secondary butterflies located? I have a edelbrock performerX intake manifold, just wondering if they are located in the stock manifold. Im running a PR3 ecu that wouldnt control the 2nd butterflies, so im gonna look for a p72 unless I dont need it due to the new manifold.
  6. T

    B18c swap into 2000 SiR ECU question

    Yes i did unplug the sensor when i adjusted the idle, i found a really good write up for cleaning and adjusting everything in these motors. I should post it here
  7. T

    B18c swap into 2000 SiR ECU question

    Ive also set timing at about 18 and running premium. Seems to be fairly good. Might try oem specs later on and see how it feels. btw inside the FITV i found it clogged with high heat silicone. Possibly was used at some point on the water pump im assuming, and was started before it could set...
  8. T

    B18c swap into 2000 SiR ECU question

    That is stock. Its a pr3. Anyways i cleaned the FITV and its much better now. Turned up idle to 1000rpm. Intown driving is much easier. Still going to look for a p72 ECU and see how that feels.
  9. T

    B18c swap into 2000 SiR ECU question

    So ive dropped a JDM b18c obd1 into my 2000 SiR. Edelbrock PerformerX Manifold, AEM adjustable fuel pressure regulator, Mugen headers, AEM CAI, Magnaflow exhaust. New valve seals, pistons and rings. Motor has 52,000 Km and is pretty much brand new. I ran a clipdown harness since im using an...
Back
Top