Where are you located?? I'm interested in the B16a Tranny but would like to Pick it up.. not interested in shipping ..
Sorry i should have read the entire post.. :rolleyes:
Too Far for me ..
if you have an A1, J1, S1 or Y1 get a 90-91 Clutch Kit if you are using a YS1 Tranny use 92-93 Clutch Kit.
The Tranny code can be found on the Clutch housing facing the front of your car.. Will be a Gold or White Sticker. If you don't have that count the Splines on the Main Shaft 25 Splines is...
88-91 Cable tranny Mainshafts are a different diameter. not sure if you know this but the 90-91 integra clutch disks are different they are 25 spline and the 92+ are a 26 spline ( splines are the center connect to the main shaft that keep it from just spinning)
so a 92+ B-series LS 5th gear set...
I would go for an Excedy Organic Racing clutch i have one and lover it . It's only about a 25% increase over stock.
www.clutchcityonline.com
with a Y1 you will need a 90-91 clutch kit..
HTH
i put in a colder spark plug and fixed it..
Where are the Forum rules i guess i need to read over them.. did you remove the pic from my sig because i went to remove it and nothing was no pic there..
I need a little help here..
I'm Running a B18c1 with 11.5 to 1 Wiseco pistons and stock fuel system exept for an adjustible FPR..
I appear to be getting Pre-Ignition only at low RPM under under a load. This only started after i put my Chipped P28 ECU in ( no Knock Sensor) . I could just swap...
USDM ITR pistons and Eagle LS Rods
Does anyone know if this will work ?? I'm concerned about the Wrist pins .. are LS Wrist pins Free floating ?? Will that matter ??
Any help would be great.
i like 15's with 205-50-15 on them .. Here is a pic of my car dropped about 2.5" with Black Fat Fives and 205-50-15's
My Car
go to www.g2ic.com and look at the full member listing they have a ton of pics with differrent setups..
HTH
yes but the rack is leaking really bad. i can get my hands on a Rack out of a G3 with really low miles on it.. would be much cheaper than rebuilding if it is a smiple bolt on or little Modification i think it would be worth it.. i'm just trying to find out if it will work or not.. :D
Just wondering if anyone has ever tried putting a G3 Integra PS Rack on a G2 Integra ?
Is this a Bolt on project or would it involve a ton of fabrication ??
Any Help would be cool.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.