Search results

  1. 34diesel34

    Pilot bearing for Fidanza flywheel?

    I have questions about the pilot bearing for my 97 Accord. I took the Fidanza flywheel to get resurfaced. When I got it back the guy at the machine shop handed me the pilot bearing and said it just fell out when they resurfaced the flywheel. I thought the pilot bearing was supposed to fit into...
  2. 34diesel34

    B16 crx header hitting cross member

    Does anybody know of a header that properly fits the 91 crx with a B16a swap. The header that I have hits the cross member. It’s a 1 pieace 4 to 1 header. I had to cut out more than half of the cross member in the center so the header would clear it. I understand having to shave a little bit off...
  3. 34diesel34

    Energy suspension ball joint boots

    I need to know if I am supposed to use the retainer clips from the factory lower ball joint boots with the energy suspension boots. I tried to put one of the retainer clips on the energy suspension boots but they won't stay in place. They will move around and fall all they way down. I noticed...
  4. 34diesel34

    Crx won't start

    Here's a list to check. battery, starter, clutch switch, main relay, ignition switch, ground wire to transmission. My problem turned out to be a bad transmission ground. It looks fine when you look at it but it will go bad too. I spent a shit load of money replacing, starters, distributors...
  5. 34diesel34

    Crx will not turnover or start

    I finally got the Crx to start after 8 months. The transmission ground cable was bad. It looks perfectly normal when looking at it. Both ends were bolted down tightly, no breaks in the wire, & no corrosion or rust. I added an extra ground wire. Bolted one end to the starter and the other end to...
  6. 34diesel34

    97 Accord transmission problem

    My 97 Accord is a manual 5 speed transmission. It will not shift gears while the car is running. When the car is not running I'm able to shift in and out of all of the gears. I have replaced the slave cylinder and clutch master cylinder twice. I have blead the lines throughly many times. The...
  7. 34diesel34

    Crx will not turnover or start

    Everything has been replaced on the car that can be replaced other than the engine. I have 2 good starters. They will not turn the engine when the key is turned. Both starters have the proper voltage when the key is turned. I have had both staters tested at autozone, & I have pulled both...
  8. 34diesel34

    Crx will not turnover or start

    No this not a new swap. I did this swap in November 2010. This started 2 years ago. It does this about twice a year. I replaced the whole distributor. I have 3 spare main relays, 3 spare ignition switches, and 3 spare starter relays. I know all of these parts can't be bad. It's done this 4 times...
  9. 34diesel34

    Crx will not turnover or start

    My 91 Crx (b16a) will not turn over or start. Here's what's been checked. 1. Battery is good 2. Starter is good 3. Ignition switch is good 4. Starter relay is good, starter fuse is good 5. Battery ground is good 6. No spark from the distributor. I bought a new one and no spark from the new one...
  10. 34diesel34

    97 Accord shifting problems

    I have a 97 Accord with a 5 speed manual transmission with shifting problems. It will not shift into any gears while the car is running. The shifter is stuck when the car is running. If the car is not running it will shift into all gears with no problem. What is causing this problem????????
  11. 34diesel34

    97 Accord manual transmission will not go into reverse.

    It's the same shift linkage that was used with the previous tranny before this one.
  12. 34diesel34

    97 Accord manual transmission will not go into reverse.

    I just bought and installed a rebuilt manual transmission for my 97 Accord. It will not shift into reverse at all. It will shift into all of the other 5 gears with no problem. What is causing this? Can this be repaired without removing the transmisssion again?
  13. 34diesel34

    Crazy Idle problem on B16a crx

    Problem was air in the coolant. It Idles smooth now. I still cannot find the coolant leak though.
  14. 34diesel34

    Crazy Idle problem on B16a crx

    It's not throwing any codes on the ecu. I saw a puddle of coolant underneath. This makes me think it could be air in the coolant. It's going to be hard to work on it today. This is what's going on here
  15. 34diesel34

    90 civic si hatch

    Repair the problems you're having with it.Then give it a good tune up and add a few performance upgrades and move on.
  16. 34diesel34

    Crazy Idle problem on B16a crx

    I'm having a crazy idle problem with my crx si. The idle is very high and constantly going up and down and staying between 2000 and 4000 rpm. I disconnected the battery and reconnected it a few times to reset the ecu but this problem will not go away. What is causing this????????
  17. 34diesel34

    Honda Ignition Coils

    I checked with autozone for the part numbers, and they said the ignition coil for the TD44U distributor is the same part number for the TD42U. I'm going to try it and see if it works.
  18. 34diesel34

    Honda Ignition Coils

    I need to know if the ignition coil out off a TD42U distributor will work in a TD44U distributor. The TD42U distributor comes on a sohc d16z6 engine, and the TD44U is what my B16a uses. The ignition coil on my B16a didn't pass the resitance test and I was wondering if the coil from the TD42U is...
  19. 34diesel34

    CRX wont start

    Yes it starts now but that wire was not loose. I took it loose to check for spark, and the car turned over when I turned the key. Then I reconnected it and the car started up. I didn't change any parts on the car, didn't find any loose wires or bad connections or bad grounds. It started up out...
  20. 34diesel34

    CRX wont start

    :confused::confused::confused: WTF. The car radomly started. No parts have been changed, and no loose grounds or bad connections were found. The only thing I did was disconnect the #1 spark plug wire to check for spark and the car tried to start when I turned the key. I reconnected it and the...
  21. Try your Search on Google

Top