Search results for query: *

I am have a bad driver side axle that I need to replace but am not 100% sure as to what axle I need to replace it with. Do i just get a 99 Si axle or a dohc del sol's. Any help on to what axle I need to replace the bad one on my sir II swap in my EG.

I know it has been talked about 100 times and am I sure you are all sick of hearing the same questionk, but for bettering of my knowledge I would like to ask the age old question of what suspension set up would be best for my hatch. I will be driving it on the track this summer and a little on...

Ok I just finished getting the motor in my car this weekend and double and triple checked to make sure evething is hooked up right. Then I went to fire it and it won't do anything execpt keep cranking and cranking, not even a putter. I replaced Dis. cap, rotor, plugs gaped my plugs at like .050...

Ok I got my B16 in my car this morning and tried to start it and I hear the fuel pump priming and it is cranking, also when I took the plugs out they have fuel on them. I am going to go buy new plugs and dis. cap. My question is what should I gap my plugs at on a B16 P30?

are all the pins in the harness that attaches to your ECU the same in all generations. I know there are big and small ones. but besides that are they all the same?

Has anyone heard anything bad or good about Buddy Club spec cams, specifically the spec 3 plus. Thanks

Anyone with a del sol throttle cable or radiator hoses for sale post price please.

Which factory radiator would be the best in a 94 hatch. Would a 97 gsr or 92 ls work?

I need a radiator for my 94 hatch swap. Preferably something stock just bigger like a ITR, or a aftermarket if in my price range. Please post anything you have for sale with price thanks.

If I buy the B16 SIR II from HMO will the axles be good to use or will they be only good for cores like some other sites that sell swaps. Also will the, Axles, Half Shaft, Shift Linkage, and Stock Motor Mounts work fine for bolting it in or do I need a mount kit and diffrent axles.

I recently installed a P28 into my 94 cx hatch running a D16Y8 motor on a P05 ecu. It was not wired for vtec so I did the wiring for the vtec solenoid and converted my car from a 1 wire O2 sensor to a 4 wire so that the P28 would work. After I completed both of these things I fired up the beast...

Hey I am getting a code 14-IAC Valve (Idle Air Control) defective circuit or unplugged / defective sensor and a code 41-Primary Oxygen Sensor - Heater circuit malfunction. After I replaced my P05 ecu in my 94 hatch with a P28 so that I could run vtec. I have already ran all my vtec wires and...

Hey sort of a rookie here to wiring, so I thought I would see if anyone could help me with what I should do with these codes. First here is the story I have a swapped D16Y8 in my 94 hatch. I was running a P05 stock ECU so I bought a P28 to run my vtec. I have only wired a few things like me...