What do I need to do to make this work. I ve seen it done on a hatch at the track it was super clean looking really want to do this to my hatch.
What I need:
Headlights
Bumper
fenders
Hood
Lower radiator support
Has anyone on this board done this
Looking for 92+95 Black full interior from a hatch can be seperate or the dash/door panels/steering wheel etc. from a 2dr.
Dont need the seats though.
Thanks
93CX w/ B16 Sir II
Just got Spoon cams for $500 off my friend w/ Aem Cam gears what valve springs do you see are the best for this setup?
Thinking about the Crowers b/c I can get them cheap.
Thanks
Looking to go All Motor for Drag in my EG hatch w/ B16 Sir
Any insight would be great
Already have:
DC 4-1 Header
Powercore Race Cat
5Zigen Cat Back
Going to make these mods very soon:
Intake? any suggestions
70MM STR Throttle Body
Skunk2 Intake Manifold
Skunk2 Stage 2 Cams or my...
Need to decide which one??
Going into a 93 Cx for mostly drag though I want to start Auto xing.
Can get Ctr for $3200
Get Gsr for around $2500
Which do you guys think is the better choice or just get a Cbr 600F3.
Thanks
Chris
Is it worth the extra $$ to get the wiring harness with the B16 swap im getting. I can just use my stock 93 CX harness and just run the vtec wires directly to the ecu. Also what kind or wire do you reccomend me using when doing this.
thanks
Chris
Plan on running sohc vtec turbo
What size turbo would you recomend? Want to run a T3/4 but don't know what trim yet. I am running this in a daily driven 93 hatch. Also what is involved in a V-afc hack b/c i hear fmu's are junk or is it easier just to get hondata. I plan on running about 6-7...
What are the advantages of running the B20 block with Ls trans vs just running the ls swap. This swap is going into a 93 Cx hatch daily driver with some drag duty every now and then. Im planning on keeping this motor n/a with mods after the swap consisting of crower cams, skunk gears and...
I have a 93 Cx w/ 98xxx mile on the car. Is this too many to do a mini-me? Is this swap worth it with the cx bottom end or only with the D15b7 DX. If I proceed to go through with this swap will it be worth my time to do this or will i still fell that i do not have enough power and just be...
I am looking to swap a 96+ LS into my EG Hatch. What
year ECU should I use b/c these engines are obd 2 is there a better Ecu year or will all Obd 1 do the trick.
Will I need and Obd 2 --> 1 Harness.
Been plotting whether to get B18b or D16z6, D16y8 for my 93 cx
hatch just made a post about d16 swap was told it runs low 15s w/
minor mods. I have about a grand for the swap and can get either motor for around the same price from my local shop. Also is it worth getting the d16y8 and going...
Want to get ideas of how fast this swap would be? I know its no B16 but it is a lot cheaper for me. With the money i will save i am going to build the engine. how many mods will it take to match the stock B16
Already have: Ractive Short Ram, 2.5 inch exhausr with HP Racing rear section no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.