Search results for query: *

are all 94-up b-series half shafts the same? im trying to use a gsr on my b16 engine and doesnt seeem to be fitting. thanks.

I just removed my power steering unit, the pump, reservoir, and belt. Should i have left the reservoir with fluid in it or was it ok that its removed. i connected the hoses together so it is still a closed system and no air aor moisture can get in but there isnt any fluid in the system. is...

i heard when you chip p28's, the programs run extremely rich. how much would all of this affect your gas mileage in regular everyday driving? also how much does this running too rich all the time have any affect on the performance and can it eventually ruin a motor? thanks

im getting an LS 5th gear synchro and putting it in my b16 tranny for obvious reasons. how do i do this and should i even bother doing it myself or take it to the pros? has anyone on this board done it and if you have how did you like it? also if you know any tech articles on tranny...

im lookin at the Honda CTR N1 crank pulley since i know about all those aluminum ones causing bottom end problems. Anybody have opinions on them or facts. If they are made by honda they should be ine , balaced, and dampered right? thanks

i decided to take the cheap way out and bought one of those "mugen" chips from ebay, yeah i know mugen dont make those, anyway, do those chip programs actually change the program of the ecu to read differently. Since some call it "reprogramming" the ecu and others just add a chip. Is there a...

im building a motor with a GSR block, B16 head and B16 pistons. i know the compression will be around 11.3:1 but do i have to worry about anyclearance issues? i know all b-series parts are interchangable but just makin sure.

i just bought a B-series half shaft for a B16A2, does anyone know if it should have 2 male sides or one male and one female. i know the one for 90-93 intgra is different than the b16 so i need to know if i got the wrong one.

i got a 2000 si head and a GSR complete bottom end. i know they will just mate right together but i was concerned about power ratings and compression. i heard this will drastically lower the compression but then i heard it will raise it because it changes the deck height. has anyone ever done...