Well Im not quite new. I had a SOHC Si in my 90 Honda Crx Hf and it blew up.. So I took the motor out and just bought another one from a store for $300. Well week later now its mess up so I told them that and they are going to give me my money back cause it was a bad motor. But now.. I am fixing to buy a B16 for my Crx. How hard is it to swap it in my car? I know you have to beat it in the corner and shift leakage and motor munts and axles. I am buying a B16 from this guy here for $2500 with 20,000 miles on it cause he wrreck it and total his rex. but he is selling me everything full swap! So i figure thats a pretty good deal. Comes with everything. ecu etc.. But is there any where i can find out how to wire the vtec and oil pressure up and everything? im pretty sure i can put it in. shouldnt be that hard. I think you gotta have you ecu pin for vtec and what do i do about the oil pressure? I know alot of people done this swap so if you could help me out and give me some information.. thanks
Should i just get a vtec controller?
vtec wire
oil pressure
knock sensor
Are those the only ones i have to wire up? or is there more
Should i just get a vtec controller?
vtec wire
oil pressure
knock sensor
Are those the only ones i have to wire up? or is there more