Recent content by b16crxsi

not sure exacally the miles, i myself put about 3000 on it and never had any problems. no grinds or bearing noise. clean up the outside and put in new oil. i installed new driveshaft seals. i also have a midshaft ill throw in

ya i got a virgin p28 ecu and obd-1 vtec engine harness. BUMP! somone build a turbo honda!

2500 shipped obo. will part out. bottom end 1600 head complete un assembled 500 trans, with lsd and new clutch 500 make offers. will be shipping from 48060

to ship ups, looks like about 260 bucks.

bump...make offers, this all has to go!

selling my b16 turbo project. engine is new, never installed or run. bottom end complete, head not assembled. block- .020 over, arp main studs, arp head studs, new oilpump, new clevite bearings. rods-eagle h beam crank- oem standard size pistons-wiseco 9.2:1 flat tops. head-port matched and...

right on man thanks a lot

my 94 integra needs a driver side axle, and i have 2 sets of axles from a 92 integra (with mid shafts) can i use the 92 teg axles in my 94 if i swap the mid shaft too? thanks!

hello i have a 94 civic cx thats starting to burn oil pretty bad. i was going to just buy a replacement engine for 400 bucks from a place in toronto. the same place has a obd1 dohc zc for 650. so if i wanted to buy this engine instaed, does anything need to be changed or modified? ill be using...

my car had similar symtoms but it turned out to be one of the O2 sensors. no light on the dash, but the red led was lit up. 1 flash. it cures my problem tho.

same shit happened to my car, i just wired it up direct with a switch. its been working fine for over a year, plus it makes you look like a pro ricer when you go flippin switches to start your car hahaha.

anyone?? sombody must have a similar set-up. cmon

sure i will try and get pics asap. i dont have the internet at my new house so i gotta do it from work. i will sell just the engine for 1000 with everything like distributer, alternator, oil pan, intake ect ect. let me know if theres anything you wouldnt want. thanks

i am selling a zc swap. its from my 1990 crx. exact miles are unknown. it runs good and has even compression. i am selling the complete engine, tranny and axles. engine has been painted black and the valve cover is a copper metallic. i am asking 1300 canadian for everything. i am located near...

i have just finished putting my built b16 into my crx. forged 9.5:1 bottom end, sofar stock cams, 1mm bigger manley exhaust valves and comp cams spring set and cleaned up the ports and a 3 angle valvejob. i have adj. cam gears also. my turbo is a t3/t4 i had at our shop. im now just finishing up...