Recent content by file-error

true but if your a big fan of stock that is new youll empty your pockets:cool:

i been looking but cant seem to find anywhere that sells an aftermarket heated leather seat anyone know of any sights that do

i believe you can still get them new from honda but it cost about 550 to get both peices new

thanks im dying for a arm rest in the rex

i started with a piece of mdf but when i went down to my basement to use the saw i found a piece of lexon... it was almost as thick as the stock radio holder. when i screwed it in i used a couple washers behind each screw to get the thickness right. i cut the console flat across so i didnt...

looks like a supra shift nob...lol

could be two differ problems 1 to rich 2 slight oil leak i think your looking at them as the same problem what you describe comming from the tail is the factory tune and no cat the oil could be from anywhere, check your oil pan it might be seeping slowly on to your header under the block...

put a picture up and people here will let you know what it is

if you lay on your back you can get it with a 10mm wrench , takes about two minuts to remove

heres where it is https://hondaswap.com/civic-crx-ef/another-post-about-fuel-problem-94566/

does this fit in rex , any body got pics of what it looks like installed

with an oil pressure gauge:rolleyes:

what did you do to the fuel system,, is it running rich? to much gas will give you a white smoke even after it is warmed up, you wont see it while driving also, did you bypass your cat or gut your cat, a factory tune doesnt burn all the gas , normally the cat will catch the extra so you...

have about 40,000 miles on them , in very good condition, i got a frien in japan and he grabed these out of an eg, i tried to make them work in my crx but i couldnt get the fronts in picture is of the front 2, i have all 4 and im selling all 4 the back two that i got in ride awsome, im upset...

i have gone all through this site to find the cure for my surge, car didnt surge with my old engine, wasnt till i rebuilt the z6 and put it in that i started to have the problem, i read everypost on fixing it. tried everything . redid the vacum lines , replaced and or cleaned all the sensors ...