Ok I bought a complete swap (97 B18b1) I was going to put in my car(97 civic hx)
OK well I got a deal on this dart sleeved block(1990 B18a1) I want to use this block for the swap I also have piston and crank.
Well the A1 has a hole on the back on the bottom right side of the block, I was told it...
Well I have the four wire plug and O2 sensor, so I should probably by pass the harness and just wire it in myself right?
Unless there is an easier way, plus anyone who has a diagram of the pins would be greatly helpful.
well a honda shop tried telling me that I could use my HX harness and HX Sensor(I would just leave it 5 wire)?
they told me just take the sensors out of the HX manifold and put them in the integras header.
I am not sure though.....
Ok well I have a 97 civic hx Obd2 I am putting in a b18b1 from a 97 integra LS Obd2.
The problem is that the harness in my civic right now has a 5wire o2 sensor plug but the b18 o2 sensor has a 4 wire setup.
Can I use my harness with a civic 5 wire o2 in the integra exhaust or will it not work?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.