Recent content by jkendall

I did notice on rywire's obd0 to obd1 instructions that there is a white wire coming from their harness. It says to connect it to the knock sensor on the back of the block. I still have the stock one hooked up from the si harness. Could this be related to my issue?

Checked IACV and it was very clean. Checked for spark again on all wires (color of the spark is BLUE) and very strong. I removed the fuel return line off of the fuel pressure regulator and while cranking I get a nice stream of fuel so I know I have enough fuel. Checked the fuel pressure and...

Here is a complete list of everything I have done. Rywire obd0 - obd1 conversion harness, P28 ECU, re-pinned obd0 harness for obd1 distributor, removed obd0 injector clips and soldered obd1s on, removed the injector resistor box by soldering the 4 red/black wires and yellow/black wire...

Finally got this swap in and the car will not crank, no clicking from the starter at all. Car has a p28 ecu, rywire obd0 to obd1 conversion harness, d16z6 distributor, a6 intake manifold, fuel injectors. All grounds are on and tight (front of tranny, thermostat, valve cover). Jumpered the...