Recent content by justaguy

I fixed the issue. The channel that is shown on the intake from the D16Y8 head above has a vacuum line that used to go to an L valve that was on the side of the thermostat housing. The JDM 15B block did not have the same hole for the sensor and that head did not have the channel. What our...

P0505 Idle Control System Malfunction is the engine code it is throwing. It is the only code. It does run normal until it is warm then it starts the very little mini revs maybe 100 rpms. I could not find any bleeder for the coolant either.

Everything is in and runing.... but i am getting surging idle.... goes from 1000RPM - 1500RPM when sitting still. I am thinking it may be the fuel maping system. Any Ideas?

Would it make more sence to take the head from the D16Y8 and put it on the D15B block? both are SOHC VTEC and D series blocks.... I have looked threw all the threads and can not find info on Vtec to Vtec only non vtec D15b to Vtec D16Y8 Any help would be greatly apprciated. Thanks

I am installing a D15B JDM into a 2000 Civic SI/EX (D16Y8) for a friend of mine. They were told that this engine would be a pretty much direct bolt in that you use the intake and exhaust from original engine and away you go. I pulled off intakes and noticed that the one has a chanel running...