Recent content by project_accord

i did a auoto to manual conversion on my 96 accord and i had the same problem. mine was because the auto car didnt come with the mount bracket attached to the car that secured the pedal from above. so slowly it bend down until the clutch wouldnt disengage anymore. i fixed it by making a bracket...

i know that the 90-91 accord ex cap is the same as the jdm h22a cap because that is what i used. i know that the 96 accord ex is internal coil but it is different than the h22a cap so if the 94-95 cap is the same as the 96 it wont work

:ditto:

I don't think that he could use the accord tcu because i believe on obd2 accords it is built into the ecu, atleast it was on my accord when i did my auto to manual swap it only had an ecu no seperate tcu.

ya mine makes the same noise and it is a new honda belt and tensioner. This is my second h22 and both have made that noise, i have just gotten used to it and accepted it for normal.

are you sure it is not a obd1 jdm distributor and he used a 92 accord cap because that is what you need to use for for it. all usdm preludes came with external coils and those caps dont fit the jdm distributor so you have to use the accord distributor cap.

you can use a p13 from a 96 prelude if you can find one. i tried to find one for a long time and couldn't, you can buy a brand new one from honda for about $700, the 96 lude was the only year they made and obd2 p13 without the immobilizer. i am running a p72 from a 96 intrgra gsr and it works...

i think that if you are hitting 115 in third gear then you don't have an h22 transmission, i know i could hit that in fourth but definatly not third. what rpm are you at at about 80 in fifth you should be around 4,000.

i am not 100% sure but i have heard that the oil filter is up higher on the block then the normal engnie but i am not sure of this and it didn't make sence to me, but you might want to check it if you have easy access to the engine

if it is a base model h22a4 then it will fit fine because i have done this with a jdm h22a/lsd tranny. If it is the h22a4 from and sh prelude then you may have to do some extra work to make it fit, such as drilling and taping holes for the normal half shaft, at least that is what i heard a while...

h22a4

are you throwing any codes?

well i dont think this will help you but i had an egr code when i did my swap but it was becasue the conversion harness didn't have the wires for the egr in it so i had to add them, check to see that the wires on your accord harness run to the right spot on the p13 ecu. also try looking for a...

i think it gives it a very solid feel, it is also adjustable to three different settings so you can adjust it to however you like it best. i set it in the middle position and have never felt the need to change it.

is this the shifter you where thinking about. if so i have it on my accord and i love it. http://www.forbiddenmotorsports.com/