i just swap the steering rack from a 91 teg (powered) and had no problems putting it in a 91 CRX (Manual steering), the front cross member will not fit because the bolt holes are positioned at an angle (the front ones are closer together so the back ones are not aligned with them). now im sure...
sunds like your relay went bad during the swap; if the part numbers are the same for these cars then the realy had to be bad if replacing it solved the problem, i'll try it without changing the relay and hope it goes ok.
it's too bad you're so far from me, i have a 91 CRX DX manual steering Rack, i replaced it with the DA's powered one, it was an easy no mods replacement so i figured you could probably use it, im looking for a pr4.
Bert
here's a how to in the CRX forum website, i like the way it looks but i think you'll have to fabricate some brackets; i'd like to do this swap myself but idk if it's worth the trouble...good luck.
CRX Community Forum • View topic - Da integra swap into a DX Crx......
i have an LS (DA) dash but i've been told that it's impossible to put in a CRX; it really doesn't fit, i think i might try to get a 94 and up teggy dash because i have a write up of how to do it even though it involves some customizing parts but it's doable. I'm new to swapping engines so i'm...
I no longer have the original DX engine wiring harness cause my buddy got rid of it since we were not going to use it. ; im going back to the original plan of using the LS wire harness for both the cabin and engine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.