Recent content by SnailTrail

don't waste your $$$ on aftermarket POS. i tried that and their solenoids were pathetically small/underpowered. My friend used PW from a 4dr EF , just switch the bottom rail, and use 2 PASSENGER SIDE solenoid motors cuz dr side will be overused and die out faster. use your stock hardware. Then...

for a highly sought after Z6 tranny ... $300 shipped 130k miles no grinds

i got 1 for $250 car had 120k on it ... pics by email Local Pickup only I live in San Diego (Spring Valley)CA 91978 comes with that shift boot/fork & a 1yr used stock clutch disc.... my email is seenmypen@yahoo.com

like how low? shipping aint cheap for these big-boys :(

$75 shipped for both light color..... 92-95 right? does it matter 2 or 4 door? Mines are from 2door i believe. :worthy:

I can beat that price, front mounted off :worthy: an Audi w/75k $200 shipped comes w/1 pipe

i got a gen I apexi Vafc $250 w/printed instructions shipped

i got some from a DC TEG coupe $60 shipped, get em b4 i sell the whole rear disc swap on eGAY.

HA HA ! dood if u want a guarantee, go buy a freaking NEW one from the DEALER c'mon this is ridiculous :nutkick:

$400 will get you one B) from a JDM SR2o-DET .

thats a nice clean wire-harness there :worthy: . great price

yup i tear up turns wif my ITR swap :mullet: . Used a teg's LCAs and beaks kit. That & my eGAY strut bar up front, almost like i got PowerSteering :D . The sway bar & LCAs & endlinks from 2nd gen Teg or EG civic are interchangeable.. also the 88-91 civic..i had a DA teg LS sway bar on my EF...

looking for some coilovers from either a 92-95 EG civic or 90-93Teg..which will fit my EG. Or so i have been told. Will offer up to $60 shipped for something OTHER than dropshits. Can trade for some used EF 88-91 Eibach Soft SPorts 1.25" front 1" rear drop uncut.

:roll: got any coil-overs less than $60 shipped ? 91978 CA

I recently did this same swap (JDM D15B) into a '92Si... replacing the original D16Z6 that had developed a rattle. Anyway... sounds like you have the correct belt for the JDM D15B... must have 103 teeth... same as the USDM D15Z1 which you apparently replaced. Count the teeth!!! The correct Honda...