Search results

  1. B

    Battery Dies Every Day

    there should be a fuse on your amp. And it sound slike you have a power wire somewhere grounding out and sending all your power through the chasis. Take it to autozone and tell them to check out your battery and alternator. They do it for free.
  2. B

    Buster Radiator

    If you do it right, it shouldn't crack again...
  3. B

    y8 intake on obd0

    Yes, it will work as long as the ports and bolt holes all line up. Make sure ou swap the sensors over. You need the obd-0 sensors on that obd-2 IM.
  4. B

    Buster Radiator

    OR go buy some JB weld, rough up the cracked area with sandpaper, clean it with rubbing alcohol, and mix an equal amount of hardener and the other one (it comes with gray and black). Spread that on the crack and let it sit over night and the next day since its pretty cold out right now. Normally...
  5. B

    Battery Dies Every Day

    It's fairly obvious that you have something draining the battery. Now, When the battery dies, do you drive it for more than 30 minutes? If not, that could be why you still have a problem. When a battery dies, and you jump start it, it needs to be recharged by the alternator for at least 30...
  6. B

    Need help replacing VTEC solenoid gasket

    Yes. That is fine. Just let the car idle with teh raiator cap off and as the fluid lowers, fill it until you cant fill anymore. Is your vtec solenoid leaking oil for sure? Is this on a D series?
  7. B

    Car wont start. B16a is getting fuel and spark.

    Hey guys, I just put my b16A back in my CRX. It ran fine before I had to swap a piston out. It is getting spark and fuel. I have a CEL 6 for the ECT sensor. It broke from old age. Getting a new one tomorrow (or tonight if I get this bitch running). That wouldnt keep it from starting would it...
  8. B

    B16A rod cap torque specs?

    Hey guys. I need to know the torque specs for a stock B16A rod cap. This is for a b16a with stock rod bolts.
  9. B

    Throwout or clutch

    A good rule of thumb, is when you replace the master cylinder to replace the slave.
  10. B

    flashing or burning

    Just add this thread to your favorites so you can find it later Friz.
  11. B

    power steering to manual

    in a daily driver, power steering is better. Unless it came without it from the factory.
  12. B

    Throwout or clutch

    you had it running in first gear with the e-brake on and it didnt stall out? Sounds like the to bearing, but I cant say for sure. Just take it to a honda certified mechanic if you arent comfortable doing it yourself. THey shouldnt chargemore than $250 to do this.
  13. B

    power steering to manual

    buddy of mine just took his pump out I think. I'll ask him and get back to you on that.... Why would you want to get rid of your power steering?
  14. B

    swaping b18c1 into 90 teg ..problem

    What you can do, is get your hands on an obd0 ecu, take the plugs (sockets) out of it (this will be the end that plugs onto the stock harness). Then get the Harness plugs from a OBD-1 honda (these are the plgus that are on the engine harness etc. NOT the ecu (they plug into the ecu). Its not...
  15. B

    Turbo camshafts

    if you put the turbo cams in, you better tune it. its gonna run like ass.
  16. B

    flashing or burning

    if you are emulating/romulating, then you are not burning chips. the information is coming directly from the program on your laptop, to the ecu via a connector that looks like a chip with wires coming from it. if you want to run the car without the laptop hooked up or not romulating, you must...
  17. B

    The best engine for 88-91 crx?

    The shift linkage os from a 90 integra and has to shortened a specific length to work properly with a 88-91 with a b series. As for the ticking, I'm not sure....try to pinpoint where it is coming from, or tell him to have them tightened, then you will buy it. for all you know it could have rod...
  18. B

    swaping b18c1 into 90 teg ..problem

    ok if you want that obd2 motor in your non obd teg, you need to get a ecu conversion harness from jakobd I'm not sure of his website anymore. Or you can get one from boomslang. I woul duse teh P28 ECU and convert it to obd1. To do this you have to get a 4 wire o2 sensor and wire it up. It is...
  19. B

    flashing or burning

    you can change setting on the fly as you datalog with no problems. The datalogging header is at CN2 on teh ecu boar, and teh ostrich plugs into teh spot where your chip is. the ostrich is basically a romulator in a more convenient form. Personally, I use a USB datalogging cable from xencron...
  20. B

    The best engine for 88-91 crx?

    3K is a good price if its a 91 in GREAT shape with no rust. Otherwise no. I paid 3K for my 91 Si with near perfect interior, no rust besides teh shitty sunroof, a nice cd player, B16 swap, 62mm BBK TB, AEM CAI, ACT clutch, rear lower tie bar, rims, steering wheel, dual bend shifter, and momo...
  21. Try your Search on Google

Back
Top