Search results

  1. I

    OBD1 B18C1 -> 00 EK - Rear T Bracket / Throttle Cable Problem

    I need a favor from someone who knows for certain that they have a 99-00 SI Rear T Bracket.... I need the length from bolt to bolt from the top bracket to the bolt hole that goes to the rubber mount. (Basically the bolts in my 1st bracket picture above). I have a feeling that the Integra...
  2. I

    OBD1 B18C1 -> 00 EK - Rear T Bracket / Throttle Cable Problem

    UPDATE Fixed the throttle cable issue. I took the throttle rotor (not sure of technical part name) off my old Y8. Then just made my own bracket to hold the throttle cable in place. So now the rotation of it is proper and the cable seats completely in the provided channel. Pulled the...
  3. I

    OBD1 B18C1 -> 00 EK - Rear T Bracket / Throttle Cable Problem

    It's a 94 GSR that I'm in the middle of putting into my 00 EX Coupe. I'm having a mess of a time trying to fit the rear T bracket to where it needs to go. From the pic below you can (hopefully) see where the red arrows are pointing at the bolt holes, but the bracket itself seems too long to fit...
  4. I

    OBD1 B18C1 into '00 EX (Parts Checklist)

    Could only find a OBD1 GSR that's local and in my price range. Ideally I would have preferred OBD2, but alas OBD1 is what I ended up with. Haven't done a OBD swap backwards, so going into somewhat uncharted waters for me. Could use some input on if I'm collecting the correct parts. If you...
  5. I

    EK AC Power Wire

    Nobody knows? :( /bump
  6. I

    EK AC Power Wire

    AC wasn't blowing cold when I turned it on. Had a look under the hood and found this wire had come loose. I can't quite figure out where it should plug back into. Any help as to where it might belong would be helpful. Thanks.
  7. I

    Y8 - Wont Start / Axle Install Problem

    Just an update.... Thank you to all who posted to try and help. I fiddled with it a bit today after work and got the car to stay running. Had a few goes at it with starting it with the ether... but finally kept it up and running around 2k RPMs for about 5 minutes to bring it up to temp...
  8. I

    Y8 - Wont Start / Axle Install Problem

    Tried the ether... BINGO! I got it to fire for a moment.. but then it crapped out. After a few times of trying the ether, I got it to stay running as long as I was on the gas pedal a bit. I let it come up to temp holding it at about 1k on the tach. But the moment I let my foot off the...
  9. I

    Y8 - Wont Start / Axle Install Problem

    It's just a B&M FPR. and yes it's adjustable. Not overly certain it's a fuel issue to be honest. The grounds are all clean and solid. I checked spark. Have new plugs, wires, distributor cap, & rotor. Timing belt marks are spot on. Fuel tank is pretty clean, fuel pump sock looks good as well...
  10. I

    Y8 - Wont Start / Axle Install Problem

    Checked out the fuel tank today. Minimal sedaments in the tank. Fuel pump sock imacculate... no crusted sedament whatsoever!! Topped off the fuel to make sure any of the bad stuff is gone. Still won't start. 2 questions now: 1) How do i check the injectors to make sure they aren't all...
  11. I

    Y8 - Wont Start / Axle Install Problem

    Another day and still no luck. Anyone come up with anything else to check?
  12. I

    Y8 - Wont Start / Axle Install Problem

    Replaced the fuel filter. Stuck my air compressor to the line and cleared it all the way out.. from the pump to filter, and from the fuel rail back to the tank... still not firing. [x] Check for spark [x] Check fuel system [ ] HELP? on a side note.. still working on knocking the...
  13. I

    Y8 - Wont Start / Axle Install Problem

    Werd. I'll try and clear out the fuel system and give it another shot at cranking tonight when I get back from work. Thanks so much for all the suggestions so far. Will post up again after getting home.
  14. I

    Y8 - Wont Start / Axle Install Problem

    WE HAVE SPARK! I thought about fuel. The needle was on E, and I filled it up to about half. I also replaced the fuel filter, but did not think about clearing out the lines. Was gonng pull out the rear seat and have a look at the fuel pump next. I have no doubt that the sock on the pump is...
  15. I

    Y8 - Wont Start / Axle Install Problem

    Plugs, wires, distributor cap, and rotor.... all new. Just got done with dinner. gonna check for spark shortly.
  16. I

    Y8 - Wont Start / Axle Install Problem

    I have 2 problems that I just can't seem to shake. Looking to see if anyone might be able to help beyond what I've read from other posts on the same topics. 1) Car turns over, but won't start. The car has sat for over 2 years. I've checked and cleaned the 3 grounds - Valve cover to driver...
  17. I

    5th and 6th gen SOHC civic parts

    nobody wants to buy my useless crap. :( *bump* anways.
  18. I

    5th and 6th gen SOHC civic parts

    projectxspeed - Sent you a PM superflybunnygirl - Sent you a PM
  19. Try your Search on Google

Back
Top