Search results

  1. 2

    1987 Prelude SI help

    I would recommend doing a swap in that case. The car was built almost 2 decades ago, the engine is probably on it's last leg. Often times when the timing built break engine damage is done. The pistons will seize up into the valve, which means you will have to rebuild the motor. On an engine...
  2. 2

    went to the dyno today

    Even if it is a different cam from the auto/man. That number is low. A stock auto cam should not be making 10-15 whp less regardless.
  3. 2

    01' Accord build up

    I am not that concerned about noise. I just don't want my car to be extremely loud right now. Anyone that lives in Henrico county knows what I am talking about. In another year I will not live here and then I will go turbo.
  4. 2

    01' Accord build up

    My car does have vtec and I was thinking that it would be loud to at the vtec crossover point. What about at low rpms though? Do you think it would still be loud then?
  5. 2

    Speed:Cost

    If you are a baller and you just insist on going N/A go for it. However, if you want to be faster w/o going broke turbo the mother! :D
  6. 2

    01' Accord build up

    I am back! It has been awhile and after a little bit of trouble with the local authorities I decided to get out of the game. Well, I have been away for atleast a year now and I bought a new to me car. I used to have a 90 accord 4 door auto-tragic. My side project was a 88 CRX SI, I sold that...
  7. 2

    DOHC or SOHC

    Regardless to tranny the DOHC is the better motor.
  8. 2

    Vehicle weights

    Go to the reference section of this site. It is great!
  9. 2

    Accord/Prelude 1/4 mile times

    2.381 shows me that you definitely had some wheel spin. You want to try and get that under 2.3. Try for atleast a 2.2 or lower. Peace*
  10. 2

    Noise coming from under the chasis

    No, I actually have had the swap in for a couple months and then it started. It is like a pop sound and it sounds like it is coming from the middle of the car towards the front. Near the tranny and drive axles.
  11. 2

    Noise coming from under the chasis

    I have done a swap. I now have a Z6 motor in there. OBD1 upgrade. What would that have to do with it?
  12. 2

    Noise coming from under the chasis

    When I go to take off kind of fast there is a low pitch bump that comes from under the chasis right up front. It only happens when I go to take off fast in 1st or reverse and I kind of dump the clutch a little bit. I was thinking maybe it is a driveshaft problem. Any suggestions?
  13. 2

    Need some LSD

    Not positive but I am pretty certain that it will not work.
  14. 2

    crx tranny, z6 block

    It will bolt up.
  15. 2

    FS: P28 Ecu stock

    Forsale: $155 plus shipping for a 1993 P28-001 from a 93 civic si. Thanks.
  16. 2

    FS:1988 CRX-SI

    I have a 1988 CRX-SI with a d16z6 swap upgraded to OBD1 P28 ECU. It has: Walboro external fuel pump, 270cc RC injectors, AEM High Flow Fuel Rail, B&M Fuel Pressure Regulator, and no cat. I don't have any pics as of yet but it is black and the paint is a little faded and there is very very...
  17. 2

    what kinda work am i looking at

    I highly reccommend wiring to obd1. Not as bad of a swap as most people think. You will be running with 99-00 Civic Si's neck and neck. Peace*
  18. 2

    O2 Sensor

    Autozone has The Bosch brand of O2 sensors which are not as expensive as a lot of others. Napa is always a good place to go for parts. If you want your wallet raped then you can go to Honda.
  19. 2

    are 12 cr pistons streetable?

    That is about the highest I have heard anyone running and still trying to stay streetable.
  20. 2

    How young is too young?

    13 is definitely too young. Tell him not to walk away from her but run! Peace :peace:
  21. Try your Search on Google

Back
Top