Search results for query: *

Folks, I purchased aftermarket axles for my 89 CRX/ Vtec swap. Unfortunately, I failed to remove the knuckle ring before installing the axles. Some folks called these "spacers" but it sure didn't seem like a spacer to me. I seemed like more of a dust shield. So bottom line, I didn't remove...

Thanks, much to the several folks who've assisted me thus far. I'm just about through my LS/Vtec swap (OBDI) into my 89 CRX (DX). (It was previously converted to MultiPoint for my old ZC). I'm down to a few last items. The 4 wire heated O2 sensor is one of them. I can't afford the OEM item...

I have OBDII injectors for a GSR and need OBDI injectors. Anyone want to swap or sell OBDI low resistance, high current, peak and hold injectors, with stock 280 cc/min or larger? Thanks, Dave K. dkasakitis@yahoo.com

Folks, I have two problems stalling my swap (LS/Vtec into 89 CRX). (had ZC motor in it). I've done the physical engine swap, coolant, vacuum, and gas line junk. I removed the engine harness from the old ZC and grafted it onto the LS/Vtec (that I'm going to run an OBDI ECU). The TPS, TW, TA...

Folks, I've swapped out my old ZC and stuff my B motor in place in my 89 CRX. I'm running an S1 tranny. HASport web site indicates that I need to remove the dust seal and the spacer in the hub. OK, I've found the dust seal sticking on the old axle, but I can't see anything that looks like a...

It's a simple question, can an OBDII GSR distributor be "direct wired" (i.e., wires cut and soldered) in place of an OBDI distributor and function properly? Background: 89 CRX (DX) converted to 4 point injection currently running old, dead, tired, leaky, ZC motor. New LS/(gsr)Vtec (motor...

Like the title says, I get the village idiot award. I thought the head on my LS/Vtec was a 1995 OBDI head. (That's what the guy who sold it to me said). It's not. It's got only one 9 wire distributor plug. It must be OBDII. I'm guessing OBDI distributors are two plug, just like my...

Folks, can someone here give me the wire colors and ECU pin outs for an OBDI distributor (from ECU side)? CYP G (cylinder position G) CYP P (cylinder position P) CKP G (crankshaft position G) CKP P (crankshaft position P) TDC G (Top Dead Center G) TDC P (Top Dead Center P) You'll find in an...

(Non-ODB to ODBI ECU). Folks, I know what wires I need to run and where I need to run them to/from to wire Vtec and O2 sensor. That's not my question. I'm asking about how you physically make the connections to the device(s) in the absence of having either EXISTING or 'donor' plugs to plug...