1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

01 ITR swap into 99 RS Teg

Discussion in 'Integra' started by P0sTaL, May 12, 2010.

  1. P0sTaL

    P0sTaL New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    May 17, 2007
    Location:
    Dont U Wanna Know....
    Hey there, im just wondering on what i need to do to make sure that the swap is as easy as pie. I have a 99 Teg (Non Vtec) and swaping in a 01 ITR motor. Im going to use the RS engine harness but need to know what wires i need to run. I was looking that i need to run the Vtec and the Knock. If there is anything else your help would be greatfull.

    Thanks
     
  2. RauL8604

    RauL8604 New Member

    Messages:
    22
    Likes Received:
    0
    Joined:
    Feb 2, 2009
    Location:
    Warren, OH
    3 Wires... Knock, Vtec pressure, and Vtec solenoid... You can find a diagram that shows which pins you need to run these wires to.
     
Verification:
Draft saved Draft deleted

Share This Page