1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

85mm Bore On Stock B20Z2

Discussion in 'Engine Building' started by Scorchin Civic, Jul 30, 2007.

  1. Scorchin Civic

    Scorchin Civic Senior Member

    Messages:
    297
    Likes Received:
    0
    Joined:
    Apr 4, 2005
    Location:
    Irving, TX
    Let me know if I am crazy but I thought I would give this a try. I will be building a all motor non v-tec setup using 85mm pistons with stock sleeves in a B20Z2. I don't plan on going over 8,000rpms so i feel for the most part that it should be a good setup once i have a good air/fuel tune. So, let me know what you peeps think about this.
     
  2. Scorchin Civic

    Scorchin Civic Senior Member

    Messages:
    297
    Likes Received:
    0
    Joined:
    Apr 4, 2005
    Location:
    Irving, TX
    Wow, so not one person has anything to say about this! I know someone has done it before and could give me a little insight about this setup.
     
Verification:
Draft saved Draft deleted

Share This Page