94 honda CIVIC HB SI

[superstreetb16]

i have a lsvtec with a gsr tranny im usin the ls half shaft with the ls axle on the driver side what axle i need for the passenger side i used an ls but when i drive the car pulls hard to the left could this be the axle???????????????

I need help

 

[xj0hnx]

LS axles work fine. Did you have the alignment corrected after the swap?

 

[superstreetb16]

no the alightment wasnt done buti just noticed my tie rod wast a little loose

 

[xj0hnx]

Yea, when you swap a motor you have to redo the alignment.

 

[phunky.buddha]

Originally posted by 92b16vx@Jul 31 2005, 04:01 PM
Yea, when you swap a motor you have to redo the alignment.

[post=533676]Quoted post[/post]​

Nah. Not if you do it right.

But yeah, get the car aligned.

 

[superstreetb16]

when i give it gas it goes straight when i let go of it it pulls to the left

 

[xj0hnx]

Turn it left into an alignment shop.

 

[jimboburgess]

I would also recommend that you get an alignment, but i know that after my swap my alignment was fine. I bet after changing over the rear brakes i should get in aligned though.

 

[5thGenLuvin]

MAke sure everything in your suspension and steering column is properly installed and then get an alignment and everything should be perfect, cause those LS halfshafts and axels are the proper ones for that swap