1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

95 CIVIC AUTO TO CABLE SWAP TRANNY????

Discussion in 'HYBRID -> EG-EK / DC' started by 91jdmteg, Jan 8, 2005.

  1. 91jdmteg

    91jdmteg Senior Member

    Messages:
    221
    Likes Received:
    0
    Joined:
    Jan 3, 2005
    O.K. I've got a 95 civic hatch with a b16a AUTO. I know i didn't put it in here, Anyways it was obdo1 but was converted to obdo to put this motor in (1st gen b16a) The car has a 95 LS auto transmission in it. I've already got all the hardware to switch it to a hydro trans. Clutch foot assembly, slave cylinder, lines, clutch reservoir. But i still need a trans what would be a good trans to run with this engine? And also would it be easier to put in a cable tranny and what would be needed to do that one instead of the hydro??? THANKS :D :worthy:
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    Cable will need the same parts as the hydraulic, minus of course the lines and resevior for the fluid, instead you run the cable. I would think the cable would be easier to do.
     
  3. 91jdmteg

    91jdmteg Senior Member

    Messages:
    221
    Likes Received:
    0
    Joined:
    Jan 3, 2005
    You always give me the best answers!!!!!! Thanks again for your info!
     
  4. b18_4door

    b18_4door Member

    Messages:
    68
    Likes Received:
    0
    Joined:
    Aug 15, 2004
    get a b16 trannny yo..shorter gears=faster lS trannys are SLOOOWer than shit
     
  5. Riceras

    Riceras Senior Member

    Messages:
    107
    Likes Received:
    0
    Joined:
    Dec 27, 2004
    Location:
    Dallas, Texas


    Hell Yeah B16 Tranny with LS motor Owns all!!!!
    (if your light)
     
Verification:
Draft saved Draft deleted

Share This Page