1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

adjusting valves

Discussion in 'General Tech and Maintenance' started by legutki, Aug 13, 2003.

  1. legutki

    legutki Senior Member

    Messages:
    258
    Likes Received:
    0
    Joined:
    Feb 24, 2003
    Would adjusting valves on a JDM be different than a USDM B18C?
     
  2. D See 2

    D See 2 Senior Member

    Messages:
    2,405
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Baltimore, MD
    i wouldn't think so
     
  3. B16

    B16 Super Moderator VIP

    Messages:
    11,539
    Likes Received:
    534
    Joined:
    Sep 30, 2002
    Location:
    yay area, CA
    it is the same
     
  4. legutki

    legutki Senior Member

    Messages:
    258
    Likes Received:
    0
    Joined:
    Feb 24, 2003
  5. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    yup, the same, and if i am not mistaken they should be often with high lift cams and if running oem cams then I believe you should check them every 20k.



    Milan
     
  6. saturn_boy96

    saturn_boy96 88 C1V1C 53D4N DR1V3R

    Messages:
    1,507
    Likes Received:
    1
    Joined:
    Dec 13, 2002
    Location:
    Sheridan, WY
    i am trying to find the tool to do this, is it called a jam nut tool?

    where can i get it from?
     
  7. B16

    B16 Super Moderator VIP

    Messages:
    11,539
    Likes Received:
    534
    Joined:
    Sep 30, 2002
    Location:
    yay area, CA
    i know snap-on makes the tool, i dont remember what its called.
     
  8. saturn_boy96

    saturn_boy96 88 C1V1C 53D4N DR1V3R

    Messages:
    1,507
    Likes Received:
    1
    Joined:
    Dec 13, 2002
    Location:
    Sheridan, WY
Verification:
Draft saved Draft deleted

Share This Page