1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b20 vtec piston and valve clearance

Discussion in 'Integra' started by jdmloc, Aug 18, 2007.

  1. jdmloc

    jdmloc New Member

    Messages:
    41
    Likes Received:
    0
    Joined:
    Jul 20, 2007
    i have bought a complete b20 b block
    and a complete b16a2 head
    and i have a B16 Intake manifold and b16 cams
    i want to take it to a machine shop and get the valve to piston clearance checked because i want to put atage 2 cams in
    so what do i do?
    like do i have to get the header attached to the block and then take it to a machine shop
    or just take them both non attached???????
    snf do i bring the stage 2 cams
    or is it fine to brign the b16 cams
    ??????
     
    Last edited: Aug 18, 2007
  2. welfare

    welfare Ancient Member

    Messages:
    1,120
    Likes Received:
    9
    Joined:
    Apr 19, 2004
    Location:
    New York
    bring them the block with the pistons installed, bring them the head with the cams installed, but keep the block and head seperate, they will do the rest.
    you don't need the manifolds
     
  3. jdmloc

    jdmloc New Member

    Messages:
    41
    Likes Received:
    0
    Joined:
    Jul 20, 2007
    ok when i bring the head
    should the b16 cams be installed or the stage 2 cams be installed???
    and thanks alot
     
  4. welfare

    welfare Ancient Member

    Messages:
    1,120
    Likes Received:
    9
    Joined:
    Apr 19, 2004
    Location:
    New York
    install your "stage 2" cams
     
  5. jdmloc

    jdmloc New Member

    Messages:
    41
    Likes Received:
    0
    Joined:
    Jul 20, 2007
    alrite
    so with the stage 2 cams
    if their is no clearance
    will they be able to fix it so their is?

    thanks again
     
Verification:
Draft saved Draft deleted

Share This Page