1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cam indentification

Discussion in 'Engine Building' started by LsvtecEg6, Jul 31, 2007.

  1. LsvtecEg6

    LsvtecEg6 New Member

    Messages:
    56
    Likes Received:
    0
    Joined:
    Jul 31, 2007
    I'm in the middle of building an lsvtec set for my hatch. I just bought a JDM Sir-g head (gsr for those who dont know) and it has skunk2 vlaves springs and retainers so I'm hoping it has skunk2 cams in it. The guy claims it had stage 3's which i doubt. Does anyone know what cams are marked as the Exhaust has an L and an 8. And the intake Has a K and a J. If these are stock cams then I want knew ones.:p
     
  2. eg6sir

    eg6sir Supa Mod Moderator VIP

    Messages:
    21,703
    Likes Received:
    321
    Joined:
    Aug 17, 2005
    Location:
    661 BK CA
  3. LsvtecEg6

    LsvtecEg6 New Member

    Messages:
    56
    Likes Received:
    0
    Joined:
    Jul 31, 2007
    Actually I did try searching. I'm starting to think they're not skunk2's. So my question is, does anyone know what these cams are? I'm just trying to figure it out.
     
  4. LsvtecEg6

    LsvtecEg6 New Member

    Messages:
    56
    Likes Received:
    0
    Joined:
    Jul 31, 2007
    Will do. Just got the shit from my dad to measure them So I'm gonna do that. Do you know the ratio for the rocker arms on a stock Gsr? Any measurements at all like that would be helpful. Then I can at least figure out the lift.
     
  5. LsvtecEg6

    LsvtecEg6 New Member

    Messages:
    56
    Likes Received:
    0
    Joined:
    Jul 31, 2007
    Yea man. Thanks.
     
Verification:
Draft saved Draft deleted

Share This Page