actionisgo
Junior Member
hello just got engine in 93 del sol and wired runs but doesnt rev up, im using p28 auto computer from 93 delsol,and now have a h22 5spd, wont rev up. what should i look for? computer no good? any help would be great,thanks.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
car runs but in limp mode h22 swap
- Thread starter actionisgo
- Start date
- Replies 4
- Views 3K
We may earn a small commission from affiliate links and paid advertisements. Terms
actionisgo
Junior Member
would the auto tranny p28 computer give me problems should i go to a 5 sped ecu?
it will give you a problem, but not like the one you are experiencing...
you can modify an auto ecu to become a manual. https://hondaswap.com/~pills has a write up on it
if you're topping out at 3500 rpms, you have a "Critical error"
pull your codes
re-check your wiring
you can modify an auto ecu to become a manual. https://hondaswap.com/~pills has a write up on it
if you're topping out at 3500 rpms, you have a "Critical error"
pull your codes
re-check your wiring
actionisgo
Junior Member
i pulled the codes, i got a 4, crank position sensor, 1 long then 9 quick so a 19, auto tranny lock up control valve, 1 long , so 10, i have a 98 h22 anyone have a diagram of crank sensor,to see if it wired correct or could tell me how, the auto tranny code, will that cause this? the ten code, intake sensor could i have the 2 mixed up? any help would be super.sam
actionisgo
Junior Member
i finally figured it all out!! the crank sensor when the wires were taped they touched each other! now it runs a1, i was wondering should i get a chipped computer now, do they make a big difference?