Cleaning up Engine bay

[asmallsol]

Right now, I am trying to clean up my engine bay as much as possible. This means trying to hide all the harness, move grounds to less noticible places, ect. When I did my swap, the few wires that I had to run, aka, knock sensor, IAB wires, ect, the way I ran them looks like shit. There are wires that just run the strech of the engine bay. Now what are the secrets to doing it right?

 

[tab]

wrap the wires discreetly in your existing harness, and re-wrap the harness with tape.

 

[ssl2k]

go to walmart and get some of the colored wiring covers

they are cheap like $5 for 15ft i think

you can get blue,red,green, black


nathan

 

[hcivic.com]

use loom and get shrink wrap and do 4 inches from every conector the loom and zi tie it all back if you run at 90's from the fire wall it looks better

 

[brian11to1]

fuck colored loom get black shrink wrap.

 

[hcivic.com]

to use shrink wrap you need to remove some conectors because it will only shrink so much