1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Clutch Issues

Discussion in 'General Tech and Maintenance' started by Havok, Oct 19, 2005.

  1. Havok

    Havok Senior Member

    Messages:
    6,827
    Likes Received:
    1
    Joined:
    Sep 28, 2002
    Location:
    Florida
    So, I get no response from the clutch until I press it in about halfway, and it sticks to the floor. Occasionally, when I start it up, it won't go into gear or it's really rough, I need to double pump the clutch to get it into gear, and I need to use my foot to pull the clutch up from the floor, sometimes it will go back into the normal position by itself.
    I'm assuming it's the slave cylinder, or master cylinder, but before I replace them, any 2nd opinions? I haven't checked them yet, but I will shortly.
     
  2. 92civicb18b1

    92civicb18b1 The Trisexual

    Messages:
    8,859
    Likes Received:
    18
    Joined:
    Oct 1, 2003
    Location:
    The asshole of the USA, New Jersey
    I'd replace both the master and slave cylinders.
     
  3. D See 2

    D See 2 Senior Member

    Messages:
    2,405
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Baltimore, MD
    Try bleeding the clutch. :)
     
  4. Havok

    Havok Senior Member

    Messages:
    6,827
    Likes Received:
    1
    Joined:
    Sep 28, 2002
    Location:
    Florida
    DTEC FTW!

    Bled the clutch, all is well.
     
  5. D See 2

    D See 2 Senior Member

    Messages:
    2,405
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Baltimore, MD
    :thumbsup:

    Whenever a problem arises, make a list of the possible causes. Then start with the easiest and work toward the hardest.
     
Verification:
Draft saved Draft deleted

Share This Page