1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

clutch problems

Discussion in 'General Tech and Maintenance' started by stuntstere, Jul 24, 2004.

  1. stuntstere

    stuntstere Member

    Messages:
    97
    Likes Received:
    0
    Joined:
    Jun 5, 2004
    when i am driving and push in the clutch to shift it sticks and then it just springs up, and my clutch doesnt disengage all the time either. would my master or slave cylinder be going out? I bled it and made sure it was full of fluid. what could it be. any help is appriciated.
     
  2. ExplicitSnow

    ExplicitSnow Senior Member

    Messages:
    142
    Likes Received:
    0
    Joined:
    Jul 19, 2004
    im not sure about hydro trannies, but i know on cable trannies, there is a pedal return spring that pops the pedal back at you...thats what was wrong w/ mine on my crx...you might want to check that out...if your master/slave cylinder were the problem, your car probably wouldnt go into gear...that was my problem on my accord
     
  3. projectxspeed

    projectxspeed Senior Member

    Messages:
    1,380
    Likes Received:
    0
    Joined:
    Nov 5, 2003
    Location:
    New Hampshire
    I had the exact same problem with my 95 integra. It turned out to be that the slave cylinder was bad. Hope that helps
     
Verification:
Draft saved Draft deleted

Share This Page