1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Compression in a...

Discussion in 'Engine Building' started by kmcrvtec, Sep 27, 2004.

  1. kmcrvtec

    kmcrvtec Junior Member

    Messages:
    5
    Likes Received:
    0
    Joined:
    Sep 11, 2004
    If I had an pr3 vtec head with je 10.5 compression piston and crower rods, what would the estimated compression be after being installed?
     
  2. phunky.buddha

    phunky.buddha Admin with a big stick Admin VIP

    Messages:
    28,465
    Likes Received:
    228
    Joined:
    Sep 30, 2002
    Location:
    Dallas / Fort Worth, TX
    10.5? :lol:

    There's no way to tell unless you specify what engine setup the 10.5 pistons are spec'd out for.
     
Verification:
Draft saved Draft deleted

Share This Page