1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

d16z6 in a 89 crx hf?

Discussion in 'General Tech and Maintenance' started by civicsi9295, Apr 30, 2006.

  1. civicsi9295

    civicsi9295 Junior Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Apr 30, 2006
    ok I know I'm new and probably overlooking something I should be doing but... I have a stock 88 hf, I have a d16z6 complete motor, I just can't seem to find any info on this particular swap. I mostly need help wiring the entire engine(d16z6) once its in, including knock sensor, vtec solenoid, rpm activated switch, IACV etc... If anyone can point me into the direction I need to be looking(whether on the web or in this forum) it would be greatly appreciated..

    Thanks
     
  2. reikoshea

    reikoshea HS Troll...And Mod Moderator VIP

    Messages:
    12,633
    Likes Received:
    193
    Joined:
    Apr 27, 2005
    Location:
    San Antonio, TX
    No joke. You doubt post again, i will eat your big toe.
     
  3. Taco15

    Taco15 I wear stretchy pants VIP

    Messages:
    6,998
    Likes Received:
    203
    Joined:
    Jan 11, 2005
    Location:
    Tallahassee Fl
    i would go obd1 man. get the conversion harness for the ecu and dizzy. my ecu choice would the p28. After that it would be pretty simple to wire up vtec,o2sensor and what not.Or if you dont want to then put the motor in hook up the 1 wire o2 and run your pm6. you wont have vtec though.
     
Verification:
Draft saved Draft deleted

Share This Page