1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DX to SI wiring question (call me a moron)

Discussion in 'ECU's, Electronics, and Tuning' started by Civic_Tacoma, Jun 7, 2004.

  1. Civic_Tacoma

    Civic_Tacoma Member

    Messages:
    94
    Likes Received:
    0
    Joined:
    Feb 19, 2003
    Location:
    Tennessee
    I'm trying to finish the install of an SI engine into my DX 4-door. I have ZERO experience doing this, but I think I'm coming along pretty good. Most of the hoses are on, and I'm ready to start the wiring part. My question is......are the wires coming from the inside on the DX the same as the wires coming out of the plugs on the DX ECU? I want to match them up with the SI wiring harness wire-to-wire. Thanks for any and all help....and YES I am a moron :p
     
  2. H22AdelSol

    H22AdelSol Senior Member

    Messages:
    505
    Likes Received:
    0
    Joined:
    Oct 26, 2003
    Location:
    san diego, california
    moron
     
  3. Civic_Tacoma

    Civic_Tacoma Member

    Messages:
    94
    Likes Received:
    0
    Joined:
    Feb 19, 2003
    Location:
    Tennessee
    Thanks! I'll take that as a yes they are the exact same.
     
  4. ndogg

    ndogg Member

    Messages:
    85
    Likes Received:
    0
    Joined:
    May 4, 2004
    what years are we talking about here? they are mostly the same but it will require adding a few wires and possibly moving a few.
     
  5. Civic_Tacoma

    Civic_Tacoma Member

    Messages:
    94
    Likes Received:
    0
    Joined:
    Feb 19, 2003
    Location:
    Tennessee
Verification:
Draft saved Draft deleted

Share This Page