1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ecu/ feul/spark problem

Discussion in 'HYBRID -> ED-EF / DA' started by B16Ablacky, Dec 20, 2006.

  1. B16Ablacky

    B16Ablacky honkey tits

    Messages:
    8
    Likes Received:
    0
    Joined:
    Dec 5, 2006
    i just dropped a jdm b16a into my 91 integra gs. everything is hooked up mechanically and electrically, or so i think. i used the obd0 to 0bd1 coversion from rywire.com. now when i finally with the swap i tried to start the car and it would turn over but no start. i later found out after some tests that my fuel pump wasnt turning on and i was getting no spark. then i just 2day tried putting my old obd0 non-vtec ecu back in place and turned the key and my fuel pump turned on but i still got no spark. what are some possibilities on what my problem is? i was thinking maybe the new ecu(pr3) i somehow "bad" or the ecu jumper harness is "bad."
    any help is much appriciated
     
Verification:
Draft saved Draft deleted

Share This Page