1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ECU Problems....PLS LOOK.

Discussion in 'ECU's, Electronics, and Tuning' started by ls ef, Jul 3, 2007.

  1. ls ef

    ls ef New Member

    Messages:
    135
    Likes Received:
    0
    Joined:
    Aug 8, 2006
    So I just completed my ls/vtec swap in my crx. I have a obd0 to obd1 jumper harness along with a chipped and socketed p28. The ecu works fine due to I just pulled it from a car a few minutes before putting in my crx. When the jumper harness and obd1 ecu is in it will not start. It turns over, sparks, and sends fuel. Now when I put my pr4 ecu in, direct plug in no jumper icluded it starts fine and runs fine. If anyone has any advice please let me know. Thanks
     
  2. civicious

    civicious FüK-VTEC VIP

    Messages:
    9,855
    Likes Received:
    629
    Joined:
    Jun 15, 2003
    Location:
    Houston, TX
    Your problem is you've got an OBD0 distributor. In order to run an obd1 ecu you need an obd1 or newer distributor.
     
  3. ls ef

    ls ef New Member

    Messages:
    135
    Likes Received:
    0
    Joined:
    Aug 8, 2006
    Ok I am wiring up an obd2 .....Thanks.
     
  4. ls ef

    ls ef New Member

    Messages:
    135
    Likes Received:
    0
    Joined:
    Aug 8, 2006
    nevermind I wired up a perfectley working obd1 disributor and still nothing
     
Verification:
Draft saved Draft deleted

Share This Page