1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ecu wiring b16a1 dx

Discussion in 'ECU's, Electronics, and Tuning' started by vdubber, Oct 7, 2003.

  1. vdubber

    vdubber Member

    Messages:
    48
    Likes Received:
    0
    Joined:
    Apr 4, 2003
    how do you remove the pins from the B and C connectors. Connecter A was easy, but B and C i cannot get out how do you do it. 90 crx dx b16a pr3
     
  2. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
  3. timEspeed

    timEspeed Senior Member

    Messages:
    275
    Likes Received:
    0
    Joined:
    Nov 13, 2002
    you gotta remove the clear plastic guards inside the connector. Theres two tabs on each side that you have to push in (i used needle nose pliers) in order to get it out. Once thats out the pins remove easily with a paper clip or safety pin. It took me a total of two hours to figure this out after riping a few wires by pulling on them.
     
Verification:
Draft saved Draft deleted

Share This Page