integrawow
Member
First, I want to let people know that I do understand how to put a b-series motor into an ED6 chassis. This thread only emphasizes my curiousity to do the swap differently.
Anyhow, I am putting a B18a/cable tranny into an ED6, and I want to keep my ED6 knuckle/spindle/hub assembly. I am wondering if I can take apart the Integra axle and do the same to the ED6 axle, but reassemble the Integra axle with the ED6 end so that I can use the ED6 hub?
Yes, it will probably be a little bit weak since it will have smaller splines. However, if someone has done this, and has broken an axle of this combination, then I might not do it. As of now, I want to do it.
Let me know!
Anyhow, I am putting a B18a/cable tranny into an ED6, and I want to keep my ED6 knuckle/spindle/hub assembly. I am wondering if I can take apart the Integra axle and do the same to the ED6 axle, but reassemble the Integra axle with the ED6 end so that I can use the ED6 hub?
Yes, it will probably be a little bit weak since it will have smaller splines. However, if someone has done this, and has broken an axle of this combination, then I might not do it. As of now, I want to do it.
Let me know!
Last edited: