1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

engine wiring harness removal

Discussion in 'HYBRID -> ED-EF / DA' started by projectDx, Nov 14, 2004.

  1. projectDx

    projectDx Junior Member

    Messages:
    27
    Likes Received:
    0
    Joined:
    Aug 24, 2004
    hey everyone,

    engine is a d15b2. there are two plugs from the wiring harness that are connected to the rear of the block, right above the oil filter, that i don't know how to remove. does anyone know how to remove them? sorry, i don't have a digi-cam or i'd take pics.

    thanks.
     
  2. ryangt

    ryangt Senior Member

    Messages:
    745
    Likes Received:
    0
    Joined:
    Sep 28, 2004

    the popular ways are yankin jiggling and wiggling or just feeling around for one of hondas famous clips
     
  3. pauls81sc

    pauls81sc Member

    Messages:
    87
    Likes Received:
    1
    Joined:
    Aug 11, 2004
    Location:
    Huntington Beach, CA
    I had similar problem with two connectors on the back of my B18A. If yours are the same type, as in they have a black rubber boot over them, then just hold the tip of the boot and give them a good pull. It worked for me.

    IF THEY DO NOT HAVE BOOTS then I would keep searching.
     
  4. hcivic.com

    hcivic.com Senior Member

    Messages:
    4,571
    Likes Received:
    2
    Joined:
    Jan 7, 2003
    Location:
    Calgary Alberta canada
    cut them off then send me 5 bucks and buy my complete harness


    but in reality you may need a small srew drive to slid in and pry them aprt
     
Verification:
Draft saved Draft deleted

Share This Page