1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

GD o2 sensor!

Discussion in 'General Tech and Maintenance' started by micah, Nov 15, 2003.

  1. micah

    micah Senior Member

    Messages:
    3,513
    Likes Received:
    2
    Joined:
    Dec 24, 2002
    Location:
    panama city beach, florida
    i have spent more then a few hours trying to get the damn o2 sensor off my stock header. a friend of mine was also over trying to get it off. and the bastard just is not budging.
    any suggestions?
     
  2. h22bubbleback

    h22bubbleback Senior Member

    Messages:
    1,559
    Likes Received:
    0
    Joined:
    Jul 18, 2003
    Location:
    North Jerzey
    get a cutting wheel and cut that old POS manifold to shyt ;)
     
  3. swanny

    swanny Senior Member

    Messages:
    3,779
    Likes Received:
    1
    Joined:
    Jul 13, 2003
    Location:
    buck teeth and government checks, PA
    heat the manifold it up with a torch til its red hot, or maybe even drive it around for a while then quench it with water and then try to take it off.
     
  4. micah

    micah Senior Member

    Messages:
    3,513
    Likes Received:
    2
    Joined:
    Dec 24, 2002
    Location:
    panama city beach, florida
    1 can of wd40, 1 pair of stanley gloves, 1 new wrench, and an hour of me and my friend both giving it hell later, the bolt came off :p
     
Verification:
Draft saved Draft deleted

Share This Page