1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

H22a1 Block help/ or block/parts wanted!

Discussion in 'Engine Building' started by civic_h22_815, Apr 1, 2007.

  1. civic_h22_815

    civic_h22_815 Junior Member

    Messages:
    5
    Likes Received:
    0
    Joined:
    Mar 18, 2005
    I have a H22 block that is missing a piston and rod and the cylinder walls are a little scratched. I was going to bore it out but my friend who is helping me said he was told I couldn't. He said I could not punch the sleeves because they are floating sleeves.So should i just buy a new block? If so, then I am looking to buy a h22a1 block and I am also looking for the internals (stock or performance). Any help or deals is greatly appreciated!
     
  2. hondasniper

    hondasniper Engine Builder

    Messages:
    99
    Likes Received:
    0
    Joined:
    Feb 21, 2005
    you should be able to get it bored out .010" over just fine (same as .25mm). don't do anything crazy like .030 or anything like that. But, it also depends on how deep of a scratch you are talking about. Worse comes to worse, you can get stock replacement sleeves if you want to go a little bigger (darton makes good stock repl. sleeves)
     
Verification:
Draft saved Draft deleted

Share This Page