1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

head gasket

Discussion in 'Engine Building' started by bigharp_civic, Sep 18, 2006.

  1. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    ok im new to hondaswap and i just wanna know one thing about my motor. i know alot of ppl put the y8 head on the block and raise compression.

    i am on a very small budget just getting out of school and i am going to go through and rebuild me motor and want to know since honda motors can handle 7-10 psi on stock internals (so i have herd) can i get a skinnier head gasket and raise compression on my motor and it still run fine for an everyday driver
     
  2. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    i have the d16z6 motor
     
  3. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    r u sure i just wanted to raise it a little to match the cr of a y8
     
  4. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
Verification:
Draft saved Draft deleted

Share This Page