1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Header For B16

Discussion in 'Engine Building' started by fardoche, Jun 12, 2003.

  1. fardoche

    fardoche Junior Member

    Messages:
    25
    Likes Received:
    0
    Joined:
    Jun 2, 2003
    I would like to hear your experiences (good or bad) with headers for the 1st gen B16.
    Tryin to decide which one to buy. Id rather go torque-wise than rev-wise, its not for a race car.
    Thanks
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    I like DC, but there are a ton of different ones on the maket. Most recommended seems to be the JDM one.
     
  3. ekPhred

    ekPhred Senior Member

    Messages:
    437
    Likes Received:
    0
    Joined:
    Nov 11, 2002
    I agree with the DC arguement. I used to have a 4-1 in my 99 si. You could feel the difference, especially in the top end. If you had the money, you can opt for the jdm header as well. good luck.
     
  4. brc80

    brc80 Senior Member

    Messages:
    1,613
    Likes Received:
    1
    Joined:
    Nov 9, 2002
    Location:
    Southern California
    I have the dc 4-1 and i really felt a diffrence, but my bro runs the jdm one and imo i like it better, thats on the ass dyno anyway.
     
Verification:
Draft saved Draft deleted

Share This Page