1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Homemade Transmission Holder for a floor jack

Discussion in 'General Tech and Maintenance' started by MthaFuknGreen, Oct 28, 2008.

  1. MthaFuknGreen

    MthaFuknGreen Green on the scene.

    Messages:
    3,166
    Likes Received:
    32
    Joined:
    Oct 1, 2008
    Location:
    Lodi, CA
    i need help in making one..
    i was thinking about just using a piece of wood and reinforcing it with 3 by 1s going opposite ways on both sides with a small gap on the bottom for it to sit on the jack.
    then putting a few more on top so every part of the tranny is supported.


    ill be swapping the transmission in my prelude on saturday, and i dont have any money to buy a holder.
    help anybody?
     
Verification:
Draft saved Draft deleted

Share This Page