1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How do I replace the low beam bulb for my 1pc

Discussion in 'Body / Exterior / Interior / Cosmetics' started by soumienchiem, Oct 28, 2004.

  1. soumienchiem

    soumienchiem Junior Member

    Messages:
    29
    Likes Received:
    0
    Joined:
    Oct 28, 2004
    For my 1-piece halo projector on my 92-95 civic hatch, my low beam bulb blew out, so I need to replace. I am having a difficult time trying to take out the light bulb that appears to be attached to the wiring stuff. How do I take it out???
     
  2. civicious

    civicious FüK-VTEC VIP

    Messages:
    9,855
    Likes Received:
    629
    Joined:
    Jun 15, 2003
    Location:
    Houston, TX
    1. unplug wiring

    2. remove bulb

    3. insert new bulb

    4. plug wires back in
     
  3. soumienchiem

    soumienchiem Junior Member

    Messages:
    29
    Likes Received:
    0
    Joined:
    Oct 28, 2004
    no no no, it doesn't look that simple. Normally, you can just pull the bulb right out on a regular headlight... but in the 1pc projector, the bulb and the wire that gives it power are attached, like they're glued on or melted on or something (not really sure). Do I just.. yank the bulb out really hard and hope that I won't break anything... or is there a certain way to take out the light bulb?
     
Verification:
Draft saved Draft deleted

Share This Page