1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

INTAKE MANIFOLD BRACE

Discussion in 'Engine Building' started by hybrid4, Dec 26, 2002.

  1. hybrid4

    hybrid4 Senior Member

    Messages:
    233
    Likes Received:
    0
    Joined:
    Dec 14, 2002
    Location:
    Nashville,TN
    i have an 88 dx, the z6 head/block with a 88 si manifold. i noticed that i had to almost remove it all the way before i could put on the i.m., is there a way to bend it, should i get the a6 brace, or better yet, take the stupid thing off? :blink:
     
  2. D See 2

    D See 2 Senior Member

    Messages:
    2,405
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Baltimore, MD
    you really dont need it just do not lean too hard on it if it's off...
     
  3. hybrid4

    hybrid4 Senior Member

    Messages:
    233
    Likes Received:
    0
    Joined:
    Dec 14, 2002
    Location:
    Nashville,TN
    AMEN! less wieght.. :worthy:
     
Verification:
Draft saved Draft deleted

Share This Page