1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

JDM Integra Typer R 5 Lug Conversion - Wheel bearing and Hub Compatibility

Discussion in 'Civic and del Sol - EG and EK' started by revillusions, Jul 15, 2008.

  1. revillusions

    revillusions New Member

    Messages:
    21
    Likes Received:
    2
    Joined:
    Jun 16, 2008
    I am currently having my JDM ITR 5 Lug Conversion installed and had a question regarding the wheel bearings and hubs.

    Because they are JDM 5 lugs, the axles are 36mm, but if I were to have a problem in the future with my wheel bearings or hubs, would I be able to use the USDM wheel bearings and hubs for replacement parts? I know I would need to exchange the axles for the 32mm USDM versions, but I wanted to make sure they would fit the JDM knuckles.
     
  2. Splat

    Splat New Member

    Messages:
    17
    Likes Received:
    0
    Joined:
    Jul 11, 2008
    I'm going though this same thing right now. Your answer is NO, the knuckle is diff and so is the bearing, and hub.
    So the US ITR wont fit.
    I should have asked this question a long time ago LOL.
    Good luck
     
  3. revillusions

    revillusions New Member

    Messages:
    21
    Likes Received:
    2
    Joined:
    Jun 16, 2008
    I guess the CRV knuckle/bearing/hub is identicle for replacement parts on the JDM 5 lug (front). Still no word yet on being able to convert the knuckle to accept a 32mm hub/bearing without machining.
     
Verification:
Draft saved Draft deleted

Share This Page