1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ls low end build

Discussion in 'Engine Building' started by ckyhimself, Sep 15, 2003.

  1. ckyhimself

    ckyhimself Member

    Messages:
    70
    Likes Received:
    0
    Joined:
    Sep 12, 2003
    Location:
    Rochester ny
    best way to build low end tq on a ls motor?? i plan on putting a turbo on next summer.. but for over winter?? would cam shafts and other things contribute... and what type of gains can i look to see ?? thanx guys
     
  2. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    84mm sleeves, Nice 9:1 pistons, crower rods and all new bearings, washers, seals, etc. for the bottom.
     
  3. saturn_boy96

    saturn_boy96 88 C1V1C 53D4N DR1V3R

    Messages:
    1,507
    Likes Received:
    1
    Joined:
    Dec 13, 2002
    Location:
    Sheridan, WY
    don't leave out the valvetrain tho, if you want to run some good turbo cams and you don't plan to run past 8k, just get your valve springs and retainers from a b16a or a gsr.
     
Verification:
Draft saved Draft deleted

Share This Page