1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

no acceloration problems d16a9 after d16a6 swap

Discussion in 'Civic and CRX - EF' started by manners13, Jun 2, 2007.

  1. manners13

    manners13 New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Feb 17, 2007
    finally done the engine swap in my rover coupe from d16a6 to d16a9 now iv got problems

    when i fully press the accelarator the car sorta chugs like hell (like when the old two stroke engine had the choke off too much and you accelarated)

    also the rev counter bounces around like mad as i hit 4000 revs or when i fully press the peddle
     
  2. welfare

    welfare Ancient Member

    Messages:
    1,120
    Likes Received:
    9
    Joined:
    Apr 19, 2004
    Location:
    New York
    check your tps and map sensor plugs you may have swapped them, just switch them and see if it fixes your problem. It's a common mistake since they are the same exact plug and so close to eachother.
     
Verification:
Draft saved Draft deleted

Share This Page